Astera ART3 Uživatelský manuál

USER MANUAL Wireless DMX Receiver/Transmitter (ART3)Manual Version: 3.2.20Release Date: July. 23rd.2010Astera LED Technolog

Color 2 Sets color 2 that is used to display programsColor 3 Sets color 3 that is used to display programsColor 4 Sets color 4 that is used to display

5 SetupThe setup offers advanced settings that can be done before or after an event like factory re-set, forming groups of lamps, calibrating colors a

RGB S RGB S..: For each pixel there are three channels RGB and one channel stroboscope.RGB RGB S S..: All RGB channels are followed by all

Standalone to keep the last input signal (for example 1 color) until another input source is chosen.Auto Automatically chooses an input sourceA

6 Technical DataGeneralTemperature (operation) 5 °C – 40 °CTemperature (transport) -25 °C – 55 °C (70 °C for 24h)Altitude up to 2000 m over sea levelE

7 TroubleshootingFaulty condition Cause TroubleshootingUnits are out of sync Adjustment of the SPEED parameter can cause deviation between the units;

8 Appendix8.1 Appendix 1: DMX tab for RC Transmitter modeSIMPLE RGB 1, 2, 3 Color of all lamps in group 14, 5, 6 Color of all lamps in group 27, 8, 9

9, 10, 11 C1 (color channel 1)12, 13, 14 C2 (color channel 2)15, 16, 17 C3 (color channel 3)18, 19, 20 C4 (color channel 4)21 Set-Address:if > 0: d

8.2 Appendix 1: Customizable ProgramsName Light Effect Used colorsONE COLOR STATIC All pixels show the same color C1TWO COLOR STATIC Same as ONE COLO

9 DisposalFollow local ordinances and/or regulations for disposal!PACKAGING:The unit is shipped in protective packaging. This packaging can be recycle

1 Table of Contents1 Table of Contents...22 Safety...

This instruction manual is part of the device and persons operating the device must have access to it at any time.Safety precautions mentioned in the

2 SafetyBefore you operate the unit, read this manual carefully. Make sure to keep the manual, in case you need to con-sult this manual again or you g

3 Getting Started3.1 IntroductionAstera's ART3 is a wireless DMX receiver/transmitter that can be used to control a setup of Astera Lamps and/or

3.2 OverviewAntenna LCD Display Navigate through menu Confirm Back / Menu Power on/off5Color Meaning XLRred Read

3.3 Mounting/Connection3.4 LCD DisplayDefinition of symbols: [1] - Receiving [3] - Transmitting[4] - Settings are stored in the memory (shown b

4 Operation ModesAs there are numerous settings, it is recommended to do a FACTORY RESET before setting them up. This can be found in the SETUP menu (

When choosing the RC Transmitter mode you can control ART3 transmitters as well as wire-less Astera lamps. Two values can be set in the RC Transmitter

4.4 RC ReceiverTo start this mode, choose RC RECEIVER in the top navigation, confirm with Enter.By using the RC Receiver mode, th